The application of varnish has long been one of the biggest challenges for pattern makers. Many have ruined a few models due to the use of poor quality varnishes or inappropriate for the job to be done, and the fact is that the varnishing process is an extremely important step in construction. For the first time, AMMO launches a complete range of varnishes for winning results on each model.
These acrylic varnishes will allow you to obtain the best results both with a brush and airbrush in a very simple way. It should be used in thin layers, and can be applied directly from the pot without dilution for a perfect finish. When used through the airbrush, we recommend spraying 6 inches (15 cm) from the surface. It is non-toxic and odorless, and dries completely within 24 hours.
This new range of varnishes has been carefully developed over a long period of time to ensure the modeler a perfect result every time. Do not take risks, use LUCKY VARNISH , a winning product that will exclude any incident that may occur when using ordinary varnishes. Available in all the usual finishes used in scale modeling, from gloss to flat.
Easy to use and simple to clean. Incredible transparent finishes for all your models, and precise for all subjects. Does not yellow or change colors. Perfect for brush and airbrush.
1- Using an airbrush, apply in light and short passes using an air pressure of 1.2 bar (17 psi), avoiding accumulation. 2- Allow to dry for at least 5 minutes between layers. DO NOT flood the surface. 3- Let dry completely for 12 hours.
No clarification needed. Clean with A.MIG-2000 acrylic thinner or water.
